Must use the high-speed usb cable provided together with the visualizer.
#QVIEW FOR PC WINDOWS#
Operating system: windows xp sp2 (service pack 2). Computer hardware requirement: cpu: 2.4ghz, ram: 256m or above, graphic card 64m, usb 2.0 port, hard disk 40g or more, monit.ĭisplay resolution higher than xga (1024*768). * please pay attention to the following: 1. Shut down your computer when prompted, so the changes will take effect. Connect the computer and visualizer with the.
#QVIEW FOR PC SOFTWARE#
Installing qomo visualizer software this function is to snap and display images with the usb interface, which includes displaying static and dynamic pictures, snapping dynamic images and playback the dynamic images with the media player in windows xp. Use the computer rs232 cable (9-pin to 9-pin) to make the rs 232 connector usb connector of the computer of the computer usb cable rs-232 cable side panel usb projector mic rgb in audio in rs232 connections shown below to control the visual. Step 6: connections for external control from the computer. Output of the s-video signal from the visualizer to the projector is already done in the step 2, where the rgb cable comes out from the visualiz. Step 4: connect to the first video equipment with s-video input. Note: you can connect a laptop computer to the rgb in port of side panel with a rgb cable. Projector rgb input screen rs232 cable side panel mic projector usb rgb in audio in rs232 projector rear panel s-video out audio video out audio audio video in s-video in. Making connections: before making any connection, turn off all the power, includin.Ĭonnect visualizer’s projector port to the rgb in port of the projector port with the rgb cable provided together the visualizer. Open the arm lights and rotate the camera head until they are in proper positions. Use one hand holds the base of the visualizer, use the other hand carefully lift up the camera stand of the unit. Remote control power (control the visualizer power on/off) rotate (rotate the image) freeze (freeze the image) lamp (control the arm lights and back light) save (save captured images) neg (display film negatives) mirror (v-reverse the image) xga (switch between svga mode and xga mode) recall (multip.Īuto (to auto adjust brightness, auto white balance and auto focus) ccd/pc1/pc2 (ccd/rgb input signal selection) s-video/ video (s-video/ video input signal selection) volume+/- (increase or decrease the volume) red+/- (increase or decrease the red hue) blue+/- (increase or decrease the blue hue) br.ġ. Save (save captured images) far/near (focus far or near) mem (multiple screen display) ppw (control the projector on/standby) pin (projector input signal selection) / (move the image up/down) power (control the visualizer on/off) ccd/pc1/pc2 (ccd/rgb input signal selection) s-video/ video (s-video/. 18 controlling the visualizer from the computer. Do not use the unit continuously for more than 24 hours with camera auto focu.Ĭontents: parts identification. Refer to qualified personnel for service only. To prevent electrical shock, do not open the cabinet. Precautions please follow these precautions: to prevent fire or shock hazard, do not expose the unit to rain or moisture.
0 kommentar(er)
